Adopt a WAN Edge from Your Juniper Installed Base

Follow these steps to adopt a previously onboarded WAN Edge into your Juniper Mist™ organization.

If you integrated your Juniper account with your Juniper Mist™ organization, you need to adopt the WAN Edges into your Juniper Mist organization.

For virtual devices, such as virtual devices such as vSRX and vSSRs, and legacy devices that predate the use of Mist claim codes on the hardware, you need to adopt, rather than claim the device. Note that if a VM has been claimed in one environment, such as Global02, it may not be available from the inventory or installed base of another environment or organization because the MAC address may still be attached to the original environment. To prevent this, be sure to release the device from the original environment, or recreate the virtual device, which will generate a new virtual MAC for it.

  1. From the left menu, select Organization > Admin > Inventory.
  2. Click Installed Base or WAN Edges at the top center of the page, and then click Adopt WAN Edges at the top right.
    User interface for managing network inventory with tabs for Access Points, Switches, WAN Edges, Mist Edges, Installed Base, dropdown menu for org Entire Org, and buttons for Adopt Switches and Adopt WAN Edges.
  3. In the WAN Edge Adoption window, follow the on-screen instructions to check the prerequisites and copy the code. Then apply the copied CLI commands to your Juniper WAN Edge.
  4. Click X in the top right corner of the WAN Edge Adoption window.
    Note:

    For detailed instructions, go to the Juniper Mist Supported Hardware page, and find the Quick Start Guide for your device.