vtep-source-interface

Syntax

Hierarchy Level

Description

Configure a source interface for a Virtual Extensible LAN (VXLAN) tunnel. This interface is usually the name of a logical interface configured on the loopback interface.

When you configure BGP deterministic path forwarding (DPF) with EVPN-VXLAN, use the colored-tunnel-address option to also specify the source VXLAN tunnel endpoint (VTEP) address for DPF.

If you specify an IPv4 address as the VTEP source address, the source VXLAN tunnel endpoint (SVTEP) encapsulates VXLAN packets with an IPv4 outer header and tunnels the packets through an IPv4 underlay network.

If you specify an IPv6 address as the VTEP source address, the SVTEP encapsulates VXLAN packets with an IPv6 outer header and tunnels the packets through an IPv6 underlay network.

Options

interface-name

Loopback interface name.

colored-tunnel-address address

When configuring BGP DPF, specify this address as the SVTEP source address that BGP advertises in EVPN routes as a deterministic Protocol Next-hop (PNH). Set this option under the inet hierarchy level for an IPv4 address, or under the inet6 hierarchy level for an IPv6 address. (See the (inet | inet6) options next.)

(inet | inet6)

Specify an IPv4 or IPv6 SVTEP address with the colored-tunnel-address option for a colored tunnel when configuring BGP DPF.

Note:

You must configure different colored tunnel addresses for MAC-VRF EVPN instances of different colored fabrics. They can't share the same VTEP address.

Required Privilege Level

routing—To view this statement in the configuration.

routing-control—To add this statement to the configuration.

Release Information

colored-tunnel-address option added in Junos OS and Junos OS Evolved 25.4R1.