ON THIS PAGE
PCEP Configuration Applied During Onboarding
This topic describes the PCEP-related configurations that are automatically generated and committed by the Routing Director during device onboarding.
For Routing Director to automatically apply the PCEP-related configurations, you need to do the following:
-
Ensure that the device is part of the network implementation plan.
-
Select the Optimization use case while creating a network implementation plan.
-
Ensure that the PCEP protocol toggle button is enabled in the device profile.
-
Ensure that the PCE Initiated toggle button is enabled in the device profile.
PCEP Configurations
When you publish the network implementation plan, Routing Director commits the following PCEP configuration at the device-level:
set groups paragon-service-orchestration protocols pcep disable-multipath-capability set groups paragon-service-orchestration protocols pcep pce pso-pce-server destination-ipv4-address PCE-VIP set groups paragon-service-orchestration protocols pcep pce pso-pce-server pce-type active set groups paragon-service-orchestration protocols pcep pce pso-pce-server pce-type stateful set groups paragon-service-orchestration protocols pcep pce pso-pce-server lsp-provisioning
Verification
After Routing Director commits the configuration to the device, use the following operational command to verify that the intended configurations have been successfully applied:
show configuration groups paragon-service-orchestration protocols pcep