EVPN VXLAN Type 5 Route Validation Probe

The EVPN VXLAN Type 5 route validation probe validates the EVPN Type 5 routes on every leaf device in the network. The collected compares the collected data with the graph data to detect missing routes on any system.

Table 1 describes the probe parameters you configure when you Instantiate the probe.

User interface for configuring a predefined probe to validate EVPN VXLAN Type-5 routes, including settings for anomaly detection, telemetry collection, and probe creation.

Table 1: EVPN VXLAN Type-5 Probe Parameters
Parameter Description
Probe Label Name to identify the probe.
Anomaly Time Window Average period duration for missing routes. The default is 2 minutes 30 seconds.
Anomaly Threshold (in %) If a route is missing for a duration equal to or greater than the specified percentage of the Anomaly Time Window, an anomaly is raised.

The Anomaly Time Window (ATW) and Anomaly Threshold (AT) are defined as follows: is AT.

The calculation for Z is performed as Z = (ATW × AT) / 100, expressed in seconds. For example: For example, if ATW is 20 seconds and AT is 5%, then Z = (20 × 5) / 100 = 1 second. An anomaly is raised when the route remains in a missing state for Z seconds within the total ATW duration.

Collection type
  • *Any: The service starts by selecting the best match among the collector definitions for that service (default setting).

  • Interval-based (CLI): Data is collected periodically by using CLI commands (not recommended).

    We recommend using gRPC/gNMI collection types which are faster and more scalable than polling CLI-based collectors.

  • Interval-based (gNMI Periodic): Data is collected periodically through gNMI.

  • Event-based (gNMI OnChange): Data is collected asynchronously through gNMI subscriptions, where updates are sent only when relevant events or value changes occur.

    Monitoring can be scoped to specific VNIs instead of the entire fabric to reduce collection overhead.

Collection period Telemetry collection interval (not applicable when the collector is in gPRC OnChange mode. The default is 2 minutes.
Missing Routes Check Interval Interval, in seconds, at which missing EVPN routes are recomputed. The default is 2 minutes.

Applies to every collection type except interval-based (CLI) and interval-based (gNMI periodic),for which missing routes are recomputed on every device telemetry round.

Streaming stages List of stages for which streaming is enabled. When specified, data streams from the configured stages to the designated receivers. See Stage Parameters for more information.

*Apstra automatically selects the optimal collection method when the collection type is set to "any" (default setting). This selection determines the Junos version and selects the most appropriate collection type.

Note: When enabled, this probe actively monitors VNIs from all devices. Unlike the EVPN VXLAN Type-3 Validation probe, it does not provide the “Monitored VNI” configuration option.
Note:

The EVPN VXLAN Route Summary analytics dashboard automatically enables the EVPN VXLAN Type-3/Type-5 Validation and XVLAN EVPN Flood List Validation probes. For information, see the EVPN VXLAN Route Summary Dashboard.