JRR200 Management and Console Port Connector Pinout Specifications

Management Port Connector Pinout Information for the JRR200 Route Reflector

The port on the front panel labeled MGMT is an autosensing 10/100/1000-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the JRR200 Route Reflector to a management LAN (or other device that supports out-of-band management). Two LEDs on the port indicate link activity on the port and the administrative status of the port.

Table 1 provides the pinout information for the RJ-45 connector for the management port. An RJ-45 cable, with a connector attached, is supplied with the JRR200 route reflector.

Table 1: Management Port Connector Pinout Information

Pin

Signal

1

TX+

2

TX-

3

RX+

4

Termination network

5

Termination network

6

RX-

7

Termination network

8

Termination network

Console Port Connector Pinout Information for the JRR200 Route Reflector

The console port is an RS-232 serial interface that uses an RJ-45 connector to connect to a console management device. The default baud rate for the console port is 9600 baud.

Table 2 provides the pinout information for the RJ-45 console connector. An Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial port adapter are supplied with the route reflector.

Table 2: Console Port Connector Pinout Information

Pin

Signal

Description

1

RTS

Request to Send

2

DTR

Data Terminal Ready

3

TXD

Transmit Data

4

Ground

Signal Ground

5

Ground

Signal Ground

6

RXD

Receive Data

7

DSR/DCD

Data Set Ready

8

CTS

Clear to Send